Hey all finally got the parts back from the laser cutters and got a mate to clean up the chassis and weld the new shock mounts on. With 6mm 350mPa steel plate and 4140 bar welded everywhere we could I doubt it will ever break. Fit together perfect too, tapped the stud in with a hammer and then tapped the whole mount into the chassis as well. Great idea getting things laser cut and not as expensive as you'd think either.
Some people were over the next day so we loaded it onto the trailer and will hopefully take it down to the galvanisers today. This is the turning point of when it starts going back together which is very exciting.
Next job is to rebuild the diffs and install a spring over axle lift in the front and a shackle flip in the back.
Cheers.
No comments:
Post a Comment